OK here is a corrected part, you have a lot of things wrong. You started out from an incorrect part, it had schematic subparts (thus no schematic as yours is not properly configured.) I replaced schematic with one generated by the Inkscape extension as being easiest. The connectors should start at 0 not 1, so I corrected that. In pcb the holes were 0.035in (for an IC) rather than 0.038in for a 0.1in header. Corrected that. Ran the part through FritzingCheckPart.py to fix up the font size problems. All these things can be found in this tutorial on part making: