Still many problems. If I didn’t mention it before, this set of tutorials apply to the current version of Fritzing and should help:
That said breadboard (all the svgs in fact) is still dimensioned in px which is incorrect and will cause problems. As well the breadboard view isn’t typical it should look more like this:
This is a breadboard svg file. Right click on the image and click save image as to download it.
which is an image extracted from a pdf data sheet. I can’t find a proper data sheet for the MX blue part (the above was taken from a red here
this is your original breadboard. The pins should align to the 0.1in grid and do not. As noted before the dimensions should be in in or mm and should have a viewbox.
So import page1 of the pdf data sheet and ungroup it. Use the circled in green part for the new breadboard symbol.
copy in the connectors from the pcb svg and set them to be invisible.
then move them over the image to be in the correct place.
Without a datasheet for the actual part I didn’t do anything about schematic of pcb. Hope this helps.
Peter