Woher bekommt msn einen Sub-D 15 poligen Stecker?

[RAPTOR7762]

Also, a Google Search for Sub-D 15-pin connector gets you a few posts:

Looking for DB15 connector with two rows of pins. need PCB only

OK here is a part that should do what you want. db15.fzpz (8.6 KB) it has all 3 views and pcb is a corrected version of your svg (the spacings were slightly off in your svg and have been corrected.) You may want to print out the pcb footprint at 1:1 scale and make sure it will do what you want. The holes for the wires are 0.035in and the nonconn holes will be drilled and have the copper pads. Peter

DB15 VGA Part Male and Female

Welcome to parts creation hell , sounds like you have already been bitten by the monsters but prevailed, hope you continue creating parts. That said there are some problems (none terribly serious): Both parts have the same moduleid so you can only load one or the other. To fix, edit one with parts editor, save as a new part (which creates a new moduleid) and export it, then copy your svg files over the ones fritzing created (except for the fpz which you need to edit to make the…

---

Google Translate: Auch eine Google-Suche nach „Sub-D 15-pin connector“ liefert Ihnen einige Beiträge:

Looking for DB15 connector with two rows of pins. need PCB only

OK here is a part that should do what you want. db15.fzpz (8.6 KB) it has all 3 views and pcb is a corrected version of your svg (the spacings were slightly off in your svg and have been corrected.) You may want to print out the pcb footprint at 1:1 scale and make sure it will do what you want. The holes for the wires are 0.035in and the nonconn holes will be drilled and have the copper pads. Peter

DB15 VGA Part Male and Female

Welcome to parts creation hell , sounds like you have already been bitten by the monsters but prevailed, hope you continue creating parts. That said there are some problems (none terribly serious): Both parts have the same moduleid so you can only load one or the other. To fix, edit one with parts editor, save as a new part (which creates a new moduleid) and export it, then copy your svg files over the ones fritzing created (except for the fpz which you need to edit to make the…

---

• Peter has edited other people’s parts, so please download his fixed parts.
• Peter hat die Teile anderer Leute bearbeitet. Laden Sie daher bitte seine korrigierten Teile herunter.

---

• Once again, if the above parts are not the same as the parts you want, please post the datasheet of the part.
• Noch einmal: Wenn die oben genannten Teile nicht mit den von Ihnen gewünschten Teilen übereinstimmen, veröffentlichen Sie bitte das Datenblatt des Teils.