Soo I thought I’d re-open this as I too was expecting the pi hat in the parts library to have the wholes cut out, at the least for the mounting screw holes, but ideally for the cut outs (which are all drawn on, but don’t appear to be set to cut out on the PCB).
Additionally is there a way to be absolutely sure the 40pin header is set on the right space, because if that doesn’t line up perfectly then the other cut outs, including the screw holes, will be off too.
I’m using this alongside the header Peter made: Raspberry Pi 40pin Header
If there’s a possibility the two could ‘snap’ into place on the PCB layout that would be exceptionally helpful.
James.