Somebody have these parts?

parts help
1

Name of the part
Waveshare UV sensor with AOUT

and

TCRT5000 IR sensor with 3 pin
OKY3513
Similar with this one:
(KY-033 Line tracing Sensor)

Top view
This picture shows the part from above, so that is easy to see were connectors should go, and which diameter they have.

UV sensor:
kép_2024-11-30_132638533

TCRT5000 with 3 pins:

image
image720×680 54.8 KB

Datasheet

Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (please specifiy)

2

These two parts should do what you want. If you want the mounting holes in pcb (they are only on silkscreen and not drilled by default) in your sketch you need to drag in core parts/hole, drag the hole over the hole in silkscreen and set the size appropriately.

waveshare-uv-sensor-9537.fzpz (11.4 KB)

OKY3513.fzpz (5.3 KB)

Peter

1 Like
3

Thank you so much for your help!