Request for the ESP32-S3 variant of the LILYGO T-ETH-Lite

parts help
1

Name of the part
LILYGO T-ETH-Lite ESP32-S3

Previous work, similar parts
A part was previously made for the non-S3 variant of this module here: Looking for LILYGO T-ETH-Lite-ESP32

I believe the only differences from that version should be a new image for the top side, and a different pinout.

Top view

image
image713×713 56 KB

Datasheet
There is no datasheet for this breakout board, but here is the pinout:

Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (please specifiy)

3

This web site would be the appropriate site to post as it has all the required information to make this part.

That said this part should do what you want. Note the mounting holes are not drilled in pcb by default they are only present on silkscreen so if you don’t want them you don’t have to modify the part. You need to drag a hole from core parts pcb in to your sketch and position it over the hole in silkscreen then set the hole size appropriately.
The POE pads in pcb are under sized to allow you to route default 24mil traces between pads to connect to the inner set (although I would guess you will use the POE daughter card instead)

LILYGO-T-ETH-Lite-ESP32-S3.fzpz (29.4 KB)

Peter

2 Likes
4

Understood, thank you for the part!