Pressure sensor MD-PS002

parts help
1

MD-PS002
Pressure Sensor MD-PS002

Anyone can help me to make parts for this sensor? The Md-PS002 is a very small and inexpensive pressure sensor. The problem lies in the fact that it is basically a Wheatstone Bridge and does not have any support electronics. This is solved through using a load amplifier like the HX711 .

Datasheet

Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (please specifiy)

Footprint
E.g. SOT23-5 , TO-220.
This usually does not apply to breakout boards.

2

A google search of the form “fritzing part MD-PS002” (which is the best way to find existing parts) finds this one I made for someone several years ago. A search in the forum search bar will also do the trick but the google search has a wider reach than just the forum.

Peter

1 Like
3

Thank you for your help, very helpful