Part Request : Degz – Power Distribution Board – Hi-Base – Hall Effect Sensor

[vanepp]

This part looks like it should be what you want.

I look for the GY-86 sensor and the BN-220 GPS modul

These two should work for some things. The gps should be fine as is, pcb for it is a 4 pin .1in header (the connector is actually 1mm but won’t fit on a pcb.) The GY-86 should be correct circuit wise, but the mounting hole and connector locations are just a guess and almost certainly wrong. If you could measure and supply the diameter of the mounting hole and the offsets in x and y from the edge of the board, and the x and y offsets from the edge of the board to the .1 connectors I will correct …

I’ll let you figure out how to connect it in your sketch as I don’t know where it needs to connect to do what you want. If you post your sketch I will look it over.

Peter