Part (multimeter) question and feedback

[vanepp]

The best bet would be to suppress the pcb layer in this case (as it isn’t useful.) Instructions on doing so are available here:

Part-creation-howto-part7-suppress-pcb-layer-howto

this is a continuation of the family and variant howto here: This howto details the various ways to suppress the pcb layer in a part. As with the earlier parts of this series I will use the yahboom super-bit part as the example. Because there is a 18650 battery (and a BBC micro:bit plugged in vertically to a socket on the super:bit) it isn’t practical to place a pcb on top of the super:bit. Rather than do the work (there are 86 connectors!) required to make pcb view work, I chose to suppress …

Peter