Looking for 5v Air Pump

[vanepp]

This part should do what you want for the driver board

pump-driver.fzpz (9.8 KB)

the pump is available here

Water pump/motor part here!

Not a bad job, but again a few problems. Breadboard lacks a layerId, and is dimensioned in px (although the scale is correct in both Fritzing and Inkscape despite that.) The motor part you cloned from is a bendable leg part and this one is not correctly configured for bendable legs so breadboard doesn’t work. This is your part in breadboard with a two pin connector beside it. Note the red squares in the header connector (which indicate active but unconnected connections.) Your part does not have…

Peter