Can I make square holes using fritzing?

[JoeAlders]

Did not find out how to do that so I am putting this question here:
Is there a possibility to produce a square hole in the PCB when using fritzing?

[vanepp]

Yes although it is a little complicated. Here is one example in a previous post in the forums.

Making A Cutout in a Part and on the PCB

This is darn-near the coolest discovery…. It turns out that making a contact pad with a Rectangular cutout is very easy. In previous post’s I referred to making simple cutouts using SVG’s ‘intrinsic’ ability to ‘Difference’ elements. Example (the SVG): I created the usual two layers; copper0 & copper1 I created a filled circle. I created a Rectangle by drawing 4 bizer lines in a CounterClockwise direction (that’s the key to intrinsic Differencing). I first selected the Circle then, …

Peter

[JoeAlders]

Thanks Peter, I will study this post.