Arduino MKR IMU Shield wanted

parts help
1

Name of the part
Arduino MKR IMU Shield

Previous work, similar parts
In case there are similar Fritzing parts, or you already started work, please link it here.

Top view
This picture shows the part from above, so that is easy to see were connectors should go, and which diameter they have.

Foto or vector graphic, no links here please.

Datasheet
The official documentation of the part manufacture is linked here:

Please add a link to PDF of the manufacturers datasheet

Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (please specifiy)

Footprint
E.g. SOT23-5 , TO-220.
This usually does not apply to breakout boards.

2

This part should do what you want. Note it doesn’t have the 4 connectors on the left end in pcb as they don’t come out to pcb.

arduino-MKR-IMU-shield.fzpz (14.3 KB)

Peter

1 Like
4

Thanks, I’m going to do my project.

5

And I also wanted MKR Motor Shield.

6

If you mean the Arduino MKR motor carrier shield it is available here:

if you want something else you need to provide a web page for what you want.

Peter