Selecting a group of parts in Schematic and then flipping causes the individual parts selected to “flip” in place. It would be nice to flip the entire block (end-for-end). I had setup some circuitry that was going to the right and needed to reorient it going left (poor planning on my part). Had to redraw everything when I could have just selected the parts and flipped/mirrored/rotated and then just moved them. If this is already a feature, my bad; couldn’t find anything via Google.
Hey, might be a bit late, but I’ve found that if you just select what you want with your cursor then go to the top menu (not right click), where it says “part”, then “rotate” and finally, the angle you want, it rotates everything you selected