OK a bit late, but here is a full part for this. I decided this would be a good example for an Arduino shield template document, and so upgraded this part to meet the standards for inclusion in core (pcb was slightly out of scale, possibly due to different Inkscape versions.) Schematic is formatted suitable for a yet to be done shield friendly Arduino part (the current part in core lacks ICSP1 and ICSP2 connections and this shield is using ICSP1 …), that is next to be done. Assuming you have one of these boards it would be very helpful if you could print out the pcb view at 1:1 scale and see if it matches the board (it should for the Arduino pins, but I’m less sure about the various jumpers. but hopefully they are in the correct place too!)
edit: I found the breadboard ICSP connector was offset 0.012in in X in the original part, just enough to cause it to not connect to the Arduino in breadboard. I have corrected that and updated the part, so if you have downloaded it, please download it again!
Dragino LoRa Shield V1.4.fzpz (17.0 KB)
Peter