Plug/Socket pairs

I need a part that lets me create a schematic where there are a bunch of parts on the left, and a bunch of parts on the right, and they are joined by an n-pin connector. One one side are some sensors and effectors; on the other side are the processor and other logic. I want to draw both the schematic and the wiring diagram in terms of these two interconnected circuits. I want a connection that logically is correct and can be realized in both schematic and “breadboard” representations, except there will not actually be a breadboard.

The generic header part should let you do this.

adjust the number of connections and sex in Inspector (the lower right window.)


Thanks, that was exactly what I needed. I had not seen the gender change for the connector because it was scrolled off the bottom of the screen.