Hi I need help with creating part:
Name of the part❗
Plasma Interface Module – PROMA
Dimensions: 115 x 60 x 25 mm
Top view❗
<This picture should show the Plasma Interface module from above, clearly indicating the placement of connectors and their approximate sizes.>
Datasheet❗
The official documentation of the part manufacturer is linked here:
Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware, mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zener diode (Z)
Other (please specify)