Consider:
My cheap trick for simulating a Part (this Post). Especially useful when time is limited and just need something that works.
For the Pads, grab the Part called “Pad”, you’ll need to copy&paste to get the quantity needed. Use the position -info at bottom of Fritzing GUI and the part/pad location box…
[SEE EDIT BELOW]
You’ll need to use a Pin Header for the round pads. Basically, you’re not building a Part but, instead, adding stuff to the PCB that the ‘bare’ chip gets soldered to…
[EDIT] Took two minutes to put the attached together.
Used two Pin Headers with THT pads
Used one Pin Header with SMC pads.
I did not mess with the dimensions… etc. Load it and look at the Info for the SMC to ensure correct pitch… etc. Also Tweak the PCB as needed… and wire it up.
You can make a Silkscreen (refer to above link)
AD5206_Phony.fzz (1.5 KB)
