Gravity: Photoelectric High Accuracy Liquid Level Sensor for Arduino
Search the part prepare before posting.
You can search for the part here:
Top right here on this page- Top right in Fritzing Application
- With the search form on fritzing.org (“Go” in the top right area)
- Appending the terms “fritzing part” in your favorite search engine
Gravity: Photoelectric High Accuracy Liquid Level Sensor for Arduino
Your previous work, similar parts
In case there are similar Fritzing parts, or you already started work, please link it here.
Please add a link to PDF of the manufacturers datasheet. N/A.
Footprint
E.g. SOT23-5 , TO-220.
This usually does not apply to breakout boards.
Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (Photoelectric High Accuracy Liquid Level Sensor)