Hello,
Could someone please tell me if it is possible to flip the PCB view of a part? I modified the attributes of the breadboard view by adding ’ fliphorizontal=“true” flipvertical=“true” 'in the breadboard view section of the .fzpz file. However, adding the same attributes to the PCB view section has no effect so far! Is that even parsed please?
Thanks for any help.
Best.
Should have mentioned that it does work very well for the breadboard view!
Apologies. Finally (!), if it is not possible to flip in PCB mode could anybody please help me to somehow flip the raspberry pi zero part? I would like to be able to insert it into a female PCB header upside down effectively. I believe I had not been designing this properly till now since I wasn’t able to flip the pi zero header…
Thanks so much.
In pcb changing the side of the board to bottom should do what you want (and move the part to the bottom of the board.)
default:
to
Peter
to
Thank you Peter! That’s a brilliant solution. It works a treat!
Much appreciated.
