ExplorIR-M CO2 Sensor

Can someone smart create this part for me. I dont know how to do this

Name of the part
ExplorIR-M CO2 Sensor

Previous work, similar parts
In case there are similar Fritzing parts, or you already started work, please link it here.

Top view
This picture shows the part from above, so that is easy to see were connectors should go, and which diameter they have.

Foto or vector graphic, no links here please.

The official documentation of the part manufacture is linked here:

Please add a link to PDF of the manufacturers datasheet

I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
[ X] Other (please specifiy) Sensor


This part should do what you want. The data sheet doesn’t specify the suggested pin diameter in pcb so I set it to -0.315in (the size of a 2mm header) as the pitch is 2mm on one side. You may need to verify the pin will fit in a 0.315in hole.

ExplorIR-M-CO2-sensor.fzpz (4.6 KB)


Thanks man!!! this design looks great! apprechiate your help!