vanepp
March 7, 2025, 8:49pm
5
The DH11 looks to be here:
OK, your font problem seems mostly to be the fonts were just too small in the svg files (there were translates as well, but that isn’t normally a problem).
Breadboard:
The layerID breadboard was missing. The only thing I know of that this breaks is exporting the part as an svg or image (the part won’t show up). I rescaled the svg (all of them actually) to be the standard scale. Many existing parts even in core are incorrectly scaled, I’m trying to fix that. The pins should start at 0 (not 8 as…
The bmp280 looks to be here:
Not bad, but a few problems:
schematic svg:
is missing the schematic layerId
none of the connectorxterminal labels are correct. 0 and 1
are still rect and 2 and 3 are labeled 4 and 5. That causes the wire to terminate in the middle of the pin as shown here:
[schem]
in the fpz file changed type=“pad” to type=“male”
edit: also changed lablel from BMP280 to M (for module)
The breadboard svg layer ID is bredboard rather than breadboard
Here is a part with these things corrected (and schema…
and the D1 mini is in core parts here:
although your image appears to be from the back of the board but the ones on the AZdelivery web site look to be the normal format and thus the one in core parts should do
Peter
via google translate
Der DH11 scheint hier zu sein:
OK, your font problem seems mostly to be the fonts were just too small in the svg files (there were translates as well, but that isn’t normally a problem).
Breadboard:
The layerID breadboard was missing. The only thing I know of that this breaks is exporting the part as an svg or image (the part won’t show up). I rescaled the svg (all of them actually) to be the standard scale. Many existing parts even in core are incorrectly scaled, I’m trying to fix that. The pins should start at 0 (not 8 as…
Der bmp280 scheint hier zu sein:
Not bad, but a few problems:
schematic svg:
is missing the schematic layerId
none of the connectorxterminal labels are correct. 0 and 1
are still rect and 2 and 3 are labeled 4 and 5. That causes the wire to terminate in the middle of the pin as shown here:
[schem]
in the fpz file changed type=“pad” to type=“male”
edit: also changed lablel from BMP280 to M (for module)
The breadboard svg layer ID is bredboard rather than breadboard
Here is a part with these things corrected (and schema…
und der D1 mini ist in Kernteilen hier:
Ihr Bild scheint zwar von der Rückseite der Platine zu sein, aber die auf der AZdelivery-Website scheinen das normale Format zu haben, und daher sollte das in Kernteilen ausreichen
Peter
