Makerfabs ESP32-S3 4G LTE CAT1 A7670X - simplified Fritzing part

Generated from user-supplied DXF: ESP32-S3 4G LTE CAT1 V1.2.dxf
Board outline: 75 x 52 mm
External header pads: 26 through-hole pads, 2.54 mm pitch
Pad coordinates in DXF/Fritzing PCB view, left-to-right:

Top row, y = 2.0 mm:
  connector0: 5V at x=38.76, y=2.00
  connector1: GND at x=41.30, y=2.00
  connector2: 3V3 at x=43.84, y=2.00
  connector3: GND at x=46.38, y=2.00
  connector4: IO38 at x=48.92, y=2.00
  connector5: IO39 at x=51.46, y=2.00
  connector6: IO40 at x=54.00, y=2.00
  connector7: IO41 at x=56.54, y=2.00
  connector8: IO42 at x=59.08, y=2.00
  connector9: RXD at x=61.62, y=2.00
  connector10: TXD at x=64.16, y=2.00
  connector11: IO2 at x=66.70, y=2.00
  connector12: IO1 at x=69.24, y=2.00

Bottom row, y = 50.0 mm:
  connector13: VBAT at x=38.76, y=50.00
  connector14: GND at x=41.30, y=50.00
  connector15: 3V3 at x=43.84, y=50.00
  connector16: IO3 at x=46.38, y=50.00
  connector17: IO8 at x=48.92, y=50.00
  connector18: SCL_IO18 at x=51.46, y=50.00
  connector19: SDA_IO17 at x=54.00, y=50.00
  connector20: IO16 at x=56.54, y=50.00
  connector21: IO15 at x=59.08, y=50.00
  connector22: IO45 at x=61.62, y=50.00
  connector23: IO9 at x=64.16, y=50.00
  connector24: IO14 at x=66.70, y=50.00
  connector25: IO46 at x=69.24, y=50.00

Notes:
- This is a simplified placement/PCB carrier component, not a complete detailed model.
- Mounting holes are shown visually on silkscreen only. Add proper Fritzing mounting-hole parts if you want drills in your carrier PCB.
- Verify by printing the PCB view at 1:1 before ordering a PCB.
