vanepp
December 6, 2016, 3:42pm
2
Try the RXB6_Superhetrodyne_receiver.fzpz from this post. The Sparkfun part is wrong (one pin too short) so I corrected it for this person with a similar board.
It sounds like you are working too hard.
Open the pcb svg in Ink,
click on each node in both copper, and anything with a 0.116 Y cord in the top main location bar with arrow selected change to 0.126.
Then in FZ Edit - Connector pick how many connectors you want active,
Then go in each view and select the connector in right-hand box, press Select Graphic, and then click on connector in main Edit window, and then select N,S,E,W in middle right box.