# HopeRF RFM69HCW ISM Transceiver

**URL:** <https://forum.fritzing.org/t/hoperf-rfm69hcw-ism-transceiver/1238>\
**Category:** parts submit\
**Created:** [May 19, 2016, 8:09pm UTC](https://forum.fritzing.org/t/hoperf-rfm69hcw-ism-transceiver/1238 "2016-05-19T20:09:32Z")\
**Posts on this page:** 1\
**Showing post:** 14

<div class="post-metadata">

**Author:** ![steelgoose](https://forum.fritzing.org/user_avatar/forum.fritzing.org/steelgoose/32/332_2.png) [@steelgoose](https://forum.fritzing.org/u/steelgoose)\
**Post date:** [May 21, 2016, 10:48pm UTC](https://forum.fritzing.org/t/hoperf-rfm69hcw-ism-transceiver/1238/14 "2016-05-21T22:48:31Z")

</div>

@Old_Grey, You can use both THT and SMD on the same part, you just need to place them in the embedded layers in the right place… see link.

> [@Etchable pancace coil](http://forum.fritzing.org/t/etchable-pancace-coil/686/21):
>
> Your two connectors IDs in your PCB view need to be labeled connector0pin and connector1pin and need to be inside the imbedded layers copper0 and copper1. If your coil is on the bottom only side then it should be in in the copper0 layer only, (see below). \<g id="copper0"\> \<g id="copper1"\> \<circle id="connector0pin" /\> \<circle id="connector1pin" /\> \</g\> \<line id="coil-1" /\> \<path id="coil-0" /\> \</g\>

---

_[View the full topic](https://forum.fritzing.org/t/hoperf-rfm69hcw-ism-transceiver/1238)._