GY-BME/P280 part

[vanepp]

No need, there already is one here (found via a google search of the form “fritzing part bme280”):

BME / BMP 280 sensor

Not bad, but a few problems: schematic svg: is missing the schematic layerId none of the connectorxterminal labels are correct. 0 and 1 are still rect and 2 and 3 are labeled 4 and 5. That causes the wire to terminate in the middle of the pin as shown here: [schem] in the fpz file changed type=“pad” to type=“male” edit: also changed lablel from BMP280 to M (for module) The breadboard svg layer ID is bredboard rather than breadboard Here is a part with these things corrected (and schema…

Peter