Unfortunately your part is not correct. Making parts is difficult. This tutorial may provide help in fixing the problems:
Otherwise waiting for @RAPTOR7762 ‘s part would be the best bet. While breadboard will technically work, it is incorrect in that standard practice is to show SMD parts mounted on breakout boards that convert to standard 0.1in breadboard spacing.
more of a problem is schematic:
Due to the lack of terminalIds the wires are connecting in the center of the pin. After that the spacing is incorrect. The pins should be on 0.1in boundaries to match the default grid size. PCB is also incorrect in that the pads are not on 1.5mm spacing (they look to vary around somewhat although possibly not enough to matter very much.) As well it is missing the silkscreen outline of the part.
In addition the font-sizes have px dimensions which will sometimes cause the font size to get very large or very small (although that doesn’t appear to have happened so far in this case.)
Peter