The thing is that the Resistor on the INA is an SMD Part which would be quite hard to replace without the nessecarry tools (that i don’t have) this was also the reason why i preferred THT and DIP over SMD and SOP Parts on my Board, because it would be easier to solder and replace. Even if the whole PCB get’s a big bigger than.
And yes i also thought about the Mosfet with a logic gate but was still confused with the explanation of how to choose the right one for it, because of the VDD, VGS and other Values that they have. So if i did a mistake there all of the current would end up in Heat. But of course a direct solution would be better than a another pcb on the board. I also don’t get why there are 2 mosfet on the board should’nt one be enough?