beginners


Any way to designate wires as input vs. output, or at least show arrows on schematic? (6)
Struggling with custom chip / modifying generic IC (15)
Fritzing and VBB (1)
Pcb negative print out (3)
How to run samples without a board (5)
Blank RPi HAT PCB ( 2 3 ) (43)
Need help programming Arduino (11)
Send data for simulation (2)
SOLVED - Resistor Confusion Over RatsNest (9)
How to change all Part Connections to Bottom layer? ( 2 ) (25)
Ground Fill with gap lines (8)
Schematic frame missing right side line, Landscape (2)
Cooper drilling question (6)
Importing .fzz file into another .fzz file (3)
Need help for an Arduino connection (7)
Measure distance between two pins (2)
How can add MQ-2 smoke detector picture in fritzing , please help me ! :( (2)
If can not find the component needed in Library (11)
PCB errors don't match Fritzing? (20)
Befuddled by the terminology and lost in the technology! (14)
Slightly Confused (4)
New Parts Editor Woes (11)
Library Contents (7)
Dc current source (4)
Custom Part Help - Did I Do This Right? (5)
Soldered Female Header Pins (2)
Can you rotate parts in increments smaller than 45deg? (3)
How do you get a standard resistor to draw as vertical on a breadboard? (12)
Pad and hols diameter (6)
Connection between arduino and shield grove (11)